Exam Code: 400-101 (Practice Exam Latest Test Questions VCE PDF)
Exam Name: CCIE Routing and Switching (v5.0)
Certification Provider: Cisco
Free Today! Guaranteed Training- Pass 400-101 Exam.
2016 May 400-101 Study Guide Questions:
Q451. Refer to the exhibit.
R2 is configured as the R1 neighbor in area 51, but R2 fails to receive the configured summary route. Which action can you take to correct the problem?
A. Replace the summary-address command with the area-range command.
B. Configure a summary address under R1interface GigabitEthernet0/0.
C. Configure a summary address under R1 interface GigabitEthernet1/0.
D. Configure the no discard-route command in the OSPF process of R1.
E. Configure ip ospf network broadcast under the Loopback0 interface of R1.
Q452. Which two statements about a network running MPLS VPN with IS-IS IGP are true? (Choose two.)
A. IS-IS traffic engineering uses wide metric TLV type 135 with an up/down bit to define a leaked route.
B. IS-IS traffic engineering uses wide metric TLV type 128 with an internal/external bit and an up/down bit to define a leaked route.
C. IS-IS traffic engineering uses wide metric TLV type 130 with an internal/external bit and an up/down bit to define a leaked route.
D. If the IS-IS up/down bit is set to 1, the leaked route originated in the L1 area.
E. The MPLS VPN IS-IS core is inherently protected against IP-based attacks.
Q453. Which protocol uses a proprietary 2-byte Type field for multiple protocol support?
Far out boson 400-101:
Q454. Which authentication types does OSPF support?
A. null and clear text
B. MD5 only
C. MD5 and clear text
D. null, clear text, and MD5
E. clear text only
Q455. Which two statements about GLBP are true? (Choose two.)
A. Packets are forwarded by multiple routers that share one virtual IP address.
B. The active router forwards packets received on one virtual IP and MAC address.
C. The standby router forwards packets when the active router fails.
D. Hosts on the network are configured with multiple gateways for load balancing.
E. Routers in a GLBP group can share multiple virtual MAC addresses.
Q456. Which two packet types does an RTP session consist of? (Choose two.)
An RTP session is established for each multimedia stream. A session consists of an IP address with a pair of ports for RTP and RTCP. For example, audio and video streams use separate RTP sessions, enabling a receiver to deselect a particular stream. The ports which form a session are negotiated using other protocols such as RTSP (using SDP in the setup method) and SIP. According to the specification, an RTP port should be even and the RTCP port is the next higher odd port number.
Tested ccie 400-101 exam cost:
Q457. Which BGP feature allows BGP routing tables to be refreshed without impacting established BGP sessions?
A. BGP synchronization
B. soft reconfiguration
D. hard reset
Clearing a BGP session using a hard reset invalidates the cache and results in a negative impact on the operation of networks as the information in the cache becomes unavailable. Soft reset is recommended because it allows routing tables to be reconfigured and activated without clearing the BGP session. Soft reset is done on a per-neighbor basis.
Reference: http://www.cisco.com/en/US/products/ps6599/products_data_sheet09186a0080087b3a.ht ml
Q458. When VRF-Lite is configured without BGP support,.which statement about the configuration of the route target and route distinguisher is true?
A. The configuration of the route target and route distinguisher is required.
B. The configuration of the route target and route distinguisher is not required.
C. The configuration of the route target is required and the configuration of the route distinguisher is not required.
D. The configuration of the route target is not required and the configuration of the route distinguisher is required.
Q459. Refer to the exhibit.
Which configuration can you implement on PE-1 to allow CE-1 to receive delegated IPv6 prefixes?
A. Exhibit A
B. Exhibit B
C. Exhibit C
D. Exhibit D
E. Exhibit E
Q460. DRAG DROP
Drag and drop the DMVPN command on the left to the corresponding function on the right.